Hardie siding installation manual

lap siding installation instructions t) james hardie@ march select cedarmill© smooth colonial smooth colonial roughsawntm beaded cedarmill beaded smooth important: failure to install and finish hardiplank@ in accordance with applicable building code compliance. James Hardie® Edge Coating To touch-up cut edges and small damages. 1 litre / ml cans. Not supplied by James Hardie Waterproof Membrane The installation of a breather membrane acting as a vapour-permeable water-barrier is necessary for timber frame buildings or block walls where the wall is not considered waterproof.  · installation manual. hardieplank lap siding. important: failure to follow james hardie written installation instructions and comply with applicable building codes may violate local laws, affect building envelope performance and may affect warranty coverage.

HardiePlank® siding HSP1/4 1/10 Store flat and keep dry and covered prior to installation. Installing siding wet or saturated may result in shrinkage at butt joints. Carry planks on edge. Protect edges and corners from breakage. James Hardie is not responsible for damage caused by improper storage and handling of the product. in., in. 10 in. widths. Please see your James Hardie dealer for local availability of these products. HardieShingle siding is available as a prefinished James Hardie product with ColorPlus® Technology. The ColorPlus coating is a factory applied, oven-baked finish available on a variety of James Hardie siding and trim products. See. From starter strips to correct gap length its important to know the basics for siding installation. Learn how to install HardiePlank lap siding on your home'.

to installation. Installing siding wet or saturated may result in shrinkage at butt joints. Carry planks on edge. Protect edges and corners from breakage. James Hardie is not responsible for damage caused by improper storage and handling of the product. INSTALLATION REQUIREMENTS - PRIMED COLORPLUS® PRODUCTS Install a 1 1/4 in. starter strip to. The trim can be made from vinyl, wood, or fiber cement products like HardieTrim®. You’ll also need to allow room for caulking, so the corners should be at least ¼” thicker than two stacked pieces of siding. Install the siding – Now it’s time to install the product itself. Fiber cement siding should be at least 6” above the grade level of the house. It is the responsibility of the installer, builder, architect or other building professional and the home or property owner to ensure the fasteners and fastening schedules used result in an installation that is code compliant. Consult ESR and ESR or other applicable, local code compliance documentation for guidance on fastener selection and placement to achieve design wind loads for the specific James Hardie siding product, framing type, building height, wind exposure category and.